Picture shows a
Security:
Heater can not be placed too close to the shower, bath and swimming pool areas.
Do not cover the heater.
Ensure that the heater away from flammable materials, and do not directly placed in the vicinity of the wall outlet.
If the heater is placed in the shower, bathroom and other wet areas, care must be placed in the position of the reach of people.
Children should be placed in easy reach.
Features:
Actual sample heater control panel:
Position switch |
Fan switch hot start
|
Thermostat
|
Restart
|
Switch gear
If you only need the fan effect, the switch to the "position one" position.
If you need the fan effect and half-power heating, the switch to the "Location 2" position.
If you need full power the fan and the heating effect, the switch to the "position three" position.
Position one position two position three
Switching equipment:
Boot time, the temperature hit the maximum, gear switch to half power or full power, begin heating. Off when the temperature homing switch go to 0, shutdown will not immediately cut off the power, the device automatically cool. People the power of nature can also be heating tube blowing cool air, then cut off the power.
Thermostat settings:
Arrow points to adjust the thermostat that needs temperature control to maintain constant temperature.
Restart settings:
The heater has a ultra-high temperature protection, once protected, require human intervention to lift, the lifting method: using a non-conductive needles into the "RESET" hole, soft reduction can be restored.
Fan switch is set to hot start
9kW/12kW/15kW fan heater to provide hot-start switch, adjust the fan forced to run or controlled by the device internal temperature automatically: when the switch is pointing to "*", the fan forces start; when the switch point "C → *", the fan the air temperature reaches a certain temperature automatically start in the air temperature falls below a certain temperature, automatically stops, the temperature of the hair to ensure comfort.
Maintenance:
Heater should be cleaned, because the internal temperature is too high will lead to fouling.
The heater has multiple protection, in addition to ultra-high temperature protection (restart), the system will start automatically after a dangerous lift.
Abnormal situation, close the power switch, check the cause of overheating, repair or contact our technical staff.
北京东方青燕原创 转载请注明出处:msg.php?id=509
上一主题:金晨柜式暖风机说明书 |
下一主题:DRF/TVC系列暖风机说明书 |